Here are some general tips for the installation of Aerogard™ film. Before installing our film please consult our more detailed written instructions and our Installation video included in all of our paint protection kits.
|
Film Installation Steps
There are a number of steps that are common to the installation of almost any component of an Aerogard™ Paint Protection Film Kit. This procedure assumes a clean and dry painted finish to start with.
|
1. The first step is to separate the film and attached liner from the clear cap sheet.
|
 |
2. Spray the painted surfaces where the film will go with soap solution. |
 |
3. Remove the white liner from the film, and spray the exposed adhesive with soap solution.
|
 |
4. The film is then positioned on the car and the top side is sprayed with soap solution. |
 |
5. The next step is to spray water-alcohol solution under the film at the starting position, |
 |
6. Then squeegee the film down at that start position to tack it in place. |
 |
7. Spray the outside of the film again with the soap solution. |
 |
8. Then squeegee the film from the start position upwards and outwards towards the edges, |
 |
9. Stretching the film with the palm of the hand, as necessary to fit the part to the car. |
 |
10. The final step is to seal and dry the film edges with a hard card wrapped in a paper towel. |
 |
